269
edits
Changes
Jump to navigation
Jump to search
# Wall power switch off (flip down white wall switch)# Unplug water pump# '''Close and lock ventilation window'''
→Shutdown Procedure
# Remove and return guides, alignment blocks, jigs, etc. to the blue Laser Guides bin or other proper storage location
# Rotate laser potentiometer to 0 (fully CCW)
# Turn off exhaust blower and air pump (upper and middle red rocker switches switch right side of laser cutter)# Turn off exhaust blower (wall switch by door)# Put the water chiller in standby mode (press the power button on the front panel, screen should read "Standby")#* '''The chiller must be put in standby before powering off or permanent damage may occur'''# Turn off water chiller (bottom red rocker switch right side of laser cutter)
# Turn off laser unit by rotating key 1/4 turn CCW); remove laser key and return to storage location
# Laser main power off (flip down blue power switch on right side of unit)
# CamFive voltage regulator off (flip down red switch on front of voltage regulator)
# Make sure any files are cleaned off the PC, or put in your userfiles folder under Hacksburg's "My Documents"
#* e.g. C:\Users\Hacksburg\My Documents\userfiles\//yourname//
