Tools/Metalworking/Mill: Difference between revisions

Jump to navigation Jump to search

Tools/Metalworking/Mill (view source)

Revision as of 16:46, 3 November 2021

839 bytes removed ,  3 November 2021
no edit summary
No edit summary
No edit summary
 
Line 17: Line 17:
! Setting excessively high jog size can cause commands to be buffered and the machine to crash! Do NOT set jog step higher than 0.5 mm or 0.02 inches!
! Setting excessively high jog size can cause commands to be buffered and the machine to crash! Do NOT set jog step higher than 0.5 mm or 0.02 inches!
|}
|}
Keyboard jogging works only when the Canvas or any non-editable field is selected. If you are in the text editor or in the command line, press <Esc> to select the Canvas.
To be filled out
 
{| class="wikitable"
! Key
! Command
|-
| Right arrow
| Pan +X
|-
| Left Arrow
| Pan -X
|-
| Up Arrow
| Pan +Y
|-
| Down Arrow
| Pan -Y
|-
| PgUp
| Pan +Z
|-
| PgDn
| Pan -Z
|-
| + or =
| Increase step by one unit (=current decade)
|-
| - or _
| Decrease step by one unit (=current decade)
|-
| 1
| Set as step the step1 (default 0.1) value from the configuration
|-
| 2
| Set as step the step2 (default 1) value from the configuration
|-
| 3
| Set as step the step3 (default 10) value from the configuration
|-
| *
| Multiply step by x10
|-
| /
| Divide step by /10
|}
 
There is also a pendant controller that can be used to send jog commands as well as G-code start and pause. To use the pendant, select the pendant icon from the toolbar on the Control tab (look for the hand icon).


== Feeds and Speeds ==
== Feeds and Speeds ==
Line 69: Line 23:
* Aluminum
* Aluminum
** 1/4" two-flute endmill, 1400 RPM, 4 IPM works well. Feed rate is limited by machine vibration.
** 1/4" two-flute endmill, 1400 RPM, 4 IPM works well. Feed rate is limited by machine vibration.
== Notes ==
https://motofaction.org/books-catalogues-brochures-manuals/rong-fu-rf-30-31-manual.pdf
Retrieved from "https://wiki.hacksburg.org/wiki/Special:MobileDiff/1650"

Navigation menu