Difference between revisions of "Tools/Electronics/GPR-6030D"
Chet Manly (talk | contribs) (Operating instructions for the GPR-6030D bench supply.) |
Chet Manly (talk | contribs) (→Usage) |
||
| Line 8: | Line 8: | ||
This is called "constant voltage" (CV) operation: the '''C.V.''' LED is lit when operating in this mode. If the current needed to stay at the voltage limit is greater than the current limit, | This is called "constant voltage" (CV) operation: the '''C.V.''' LED is lit when operating in this mode. If the current needed to stay at the voltage limit is greater than the current limit, | ||
then the supply operates in "constant current" (CC) mode instead, and the '''C.C.''' LED is lit instead of '''C.V.'''. In CC mode, the supply holds current constant at the current limit | then the supply operates in "constant current" (CC) mode instead, and the '''C.C.''' LED is lit instead of '''C.V.'''. In CC mode, the supply holds current constant at the current limit | ||
| − | and allows voltage to vary. Thus, it's possible to | + | and allows voltage to vary. Thus, it's possible to supply a constant voltage ''or'' a constant current with this supply. To provide constant voltage, set the current limit higher |
than the amount of current your load will draw at the intended supply voltage. To provide constant current, set the voltage limit higher than the voltage needed to drive the desired current | than the amount of current your load will draw at the intended supply voltage. To provide constant current, set the voltage limit higher than the voltage needed to drive the desired current | ||
through the load. | through the load. | ||
Revision as of 08:45, 18 May 2022
The GPR-6030D is a regulated DC power supply. Hacksburg's GPR-6030D is owned by a member but has no restrictions on use. The supply can provide up to 180 W of output power, and has built-in overload and reverse-polarity protection. Output can be set anywhere between 0-60 V and 0-3 A using the knobs for voltage and current on the front panel.
Usage
To use this supply, you set upper limits for both output voltage and output current. The supply then initially tries to keep its output at the voltage limit, by allowing current to vary. This is called "constant voltage" (CV) operation: the C.V. LED is lit when operating in this mode. If the current needed to stay at the voltage limit is greater than the current limit, then the supply operates in "constant current" (CC) mode instead, and the C.C. LED is lit instead of C.V.. In CC mode, the supply holds current constant at the current limit and allows voltage to vary. Thus, it's possible to supply a constant voltage or a constant current with this supply. To provide constant voltage, set the current limit higher than the amount of current your load will draw at the intended supply voltage. To provide constant current, set the voltage limit higher than the voltage needed to drive the desired current through the load.
To set the voltage limit, make sure the current limit is set high enough that you're in CV mode (C.V. lit), and adjust the voltage knobs until the readout above them indicates the desired voltage. Even if nothing is connected to the supply, you'll still need to set the current limit at least a hair above zero to put it CV mode.
To set the current limit, temporarily short the - and + terminals together with a piece of wire or a banana plug patch cord. The supply should be in CC mode, with C.C. lit. Adjust the current knobs until the readout above them indicates the desired current. (Make sure the conductor you use to short the terminals together is large enough to safely carry the current you're dialing in.)
