56
edits
Changes
Jump to navigation
Jump to search
*
→Machine Tool Power Up
** Air back on
** Power for 220 VFD: behind crates, bottom of the metal shelf
[[File:220 VFD behind crates.jpg|thumb|left|thumb]]
** Radiator: beige box on floor, top right rocker.
[[File:Radiator for CNC.jpg|thumb|left|thumb]]
** Spindle will ramp up to 24k. Load & run Warmup.ngc on screen scroll list
** Clear the spindle, then hit play. Caution: it’s quiet! 8 minutes, then it stops
* check See progress on Henry’s the touch screen
* Check motor housing for shake, heat. Should be cool to touch, else the bearings are first suspect
* Wiggle -check workpiece.
* Remove dust shoe to layout workpiece zero
* X0 Y0
* Set the tool in collet
* Hold tool, press pedal until completely out, release pedal
* Leave pedal in the location where it is tough to accidentally hit* Hold tool collet just under, press pedal tough to air clean a few seconds, push tool up and release pedal to catch spindlecollet. Test spin with fingers and pull by hand to ensure seating.
* X zero: Machine is actually in metric mode for input values, but displays “inches”. Or “in”. It wakes up in metric mode. So input a 1/4” as 6.35.
* Replace dust shoe- magnet catch. Adjust dust feet with wing nuts for brush to contact work surface.
[[File:Dust brush fixture clamp.jpg|thumb|left|Pointing at the fixture clamp for adjusting dust shoe in Z axis]]
*
* Load your guide by inserting thumb drive in back of controller
* Press black folder and find thumb drive, folder and file. Then find file in drop down list
*
[[File:Browse Files.jpg|thumb|left|Browsing files using the touch screen]]
* Hook in dust hose
[[File:Connect dust hose.jpg|thumb|left|Connect the dust hose to the brush guard]]
* Check everything!
* Turn on dust collection, gate open for your hose
