56
edits
Tools/Onefinity: Difference between revisions
→Machine Tool Power Up
| Line 89: | Line 89: | ||
** Air back on | ** Air back on | ||
** Power for 220 VFD: behind crates, bottom of the metal shelf | ** Power for 220 VFD: behind crates, bottom of the metal shelf | ||
[[File:220 VFD behind crates.jpg|left | [[File:220 VFD behind crates.jpg|thumb|left]] | ||
** Radiator: beige box on floor, top right rocker. | ** Radiator: beige box on floor, top right rocker. | ||
[[File:Radiator for CNC.jpg|left | [[File:Radiator for CNC.jpg|thumb|left]] | ||
** Spindle will ramp up to 24k. Load & run Warmup.ngc on screen scroll list | ** Spindle will ramp up to 24k. Load & run Warmup.ngc on screen scroll list | ||
** Clear the spindle, then hit play. Caution: it’s quiet! 8 minutes, then it stops | ** Clear the spindle, then hit play. Caution: it’s quiet! 8 minutes, then it stops | ||
* | * See progress on the touch screen | ||
* Check motor housing for shake, heat. Should be cool to touch, else the bearings are first suspect | * Check motor housing for shake, heat. Should be cool to touch, else the bearings are first suspect | ||
* Wiggle check workpiece. | * Wiggle-check workpiece. | ||
* Remove dust shoe to layout workpiece zero | * Remove dust shoe to layout workpiece zero | ||
* X0 Y0 | * X0 Y0 | ||
* Set the tool in collet | * Set the tool in collet | ||
* Hold tool, press pedal until completely out, release pedal | * Hold tool, press pedal until completely out, release pedal | ||
* Leave pedal tough to accidentally hit | * Leave pedal in the location where it is tough to accidentally hit | ||
* Hold tool collet just under, press pedal | * Hold tool collet just under, press pedal to air clean a few seconds, push tool up and release pedal to catch collet. Test spin with fingers and pull by hand to ensure seating. | ||
* X zero: Machine is actually in metric mode for input values, but displays “inches”. Or “in”. It wakes up in metric mode. So input a 1/4” as 6.35. | * X zero: Machine is actually in metric mode for input values, but displays “inches”. Or “in”. It wakes up in metric mode. So input a 1/4” as 6.35. | ||
* Replace dust shoe- magnet catch. Adjust dust feet with wing nuts for brush to contact work surface. | * Replace dust shoe- magnet catch. Adjust dust feet with wing nuts for brush to contact work surface. | ||
[[File:Dust brush fixture clamp.jpg|thumb|left|Pointing at the fixture clamp for adjusting dust shoe in Z axis]] | |||
* | * | ||
* Load your guide by inserting thumb drive in back of controller | * Load your guide by inserting thumb drive in back of controller | ||
| Line 112: | Line 112: | ||
* Press black folder and find thumb drive, folder and file. Then find file in drop down list | * Press black folder and find thumb drive, folder and file. Then find file in drop down list | ||
* | * | ||
[[File:Browse Files.jpg|thumb|left|Browsing files using the touch screen]] | |||
* Hook in dust hose | * Hook in dust hose | ||
[[File:Connect dust hose.jpg|thumb|left|Connect the dust hose to the brush guard]] | |||
* Check everything! | * Check everything! | ||
* Turn on dust collection, gate open for your hose | * Turn on dust collection, gate open for your hose | ||