56
edits
Tools/Onefinity: Difference between revisions
no edit summary
No edit summary |
No edit summary |
||
| Line 76: | Line 76: | ||
# M30 'end of the program | # M30 'end of the program | ||
=== Machine Tool | === Machine Tool Power Up=== | ||
* Air compressor on | * Air compressor on | ||
* Air valve (red) on | * Air valve (red) on | ||
| Line 86: | Line 86: | ||
* Carpet tape! Weight down workpiece | * Carpet tape! Weight down workpiece | ||
* Warm up procedure: | * Warm up procedure: | ||
* Air back on | ** Air back on | ||
* Power for 220 VFD: behind crates | ** Power for 220 VFD: behind crates | ||
* Radiator: beige box on floor, top right rocker. | ** Radiator: beige box on floor, top right rocker. | ||
* Spindle will ramp up to 24k. Load & run Warmup.ngc on screen scroll list | ** Spindle will ramp up to 24k. Load & run Warmup.ngc on screen scroll list | ||
* Clear the spindle, then hit play. Caution: it’s quiet! 8 minutes, then it stops | ** Clear the spindle, then hit play. Caution: it’s quiet! 8 minutes, then it stops | ||
* check on Henry’s touch screen | |||
* Check motor housing for shake, heat. Should be cool to touch, else the bearings are first suspect | * Check motor housing for shake, heat. Should be cool to touch, else the bearings are first suspect | ||
* Wiggle check workpiece. | * Wiggle check workpiece. | ||
| Line 111: | Line 111: | ||
* Check everything! | * Check everything! | ||
* Turn on dust collection, gate open for your hose | * Turn on dust collection, gate open for your hose | ||
=== Run the Gcode!=== | |||
* Play button becomes the pause button. Hover your finger a while to be ready for any weirdness. | * Play button becomes the pause button. Hover your finger a while to be ready for any weirdness. | ||
* Issue with job: screen pause | * Issue with job: screen pause | ||
| Line 117: | Line 117: | ||
* See “remaining” indicator for job time. Progress bar is by line# | * See “remaining” indicator for job time. Progress bar is by line# | ||
* Scroll display to x,y,x readout. | * Scroll display to x,y,x readout. | ||
* Hearing protection | * Hearing protection | ||
=== Shut down process === | |||
* At job end, use dust collector to clean area, then turn off. | * At job end, use dust collector to clean area, then turn off. | ||
* If you take out your tool, leave a tool in the spindle to keep it clean and spring catch engaged | * If you take out your tool, leave a tool in the spindle to keep it clean and spring catch engaged | ||
| Line 126: | Line 126: | ||
* Turn off the 220 Volt VFD | * Turn off the 220 Volt VFD | ||
* Turn off controller | * Turn off controller | ||
* Clean up everything | |||