Hacksburg Wiki

The wiki for Blacksburg's Workshop

User Tools

Site Tools


tools:3d_printing:creality_cr-10_s4

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
tools:3d_printing:creality_cr-10_s4 [2019/01/02 02:09]
alxhggrty
tools:3d_printing:creality_cr-10_s4 [2019/01/13 21:17] (current)
username Fixed issue with flow rate.
Line 36: Line 36:
   - Navigate to "Print from SD card". You may need to refresh the list to find your file. **Note:** The display shows only the first 15 characters of the filename, so save your files accordingly.   - Navigate to "Print from SD card". You may need to refresh the list to find your file. **Note:** The display shows only the first 15 characters of the filename, so save your files accordingly.
   - Select your file and begin printing   - Select your file and begin printing
-  - under "​tune"​ on the printer select flow and set it to 180.+  - <del>under "​tune"​ on the printer select flow and set it to 180.</​del>​ This issue has been resolved as of 1/13/19
   - In the event of a printing error, press the dial and navigate to **Stop Print** and wait for the printer to stop moving, then navigate to Prepare:​Move Axis:Move Z:10 mm and turn the dial to move the extruder above the print bed.   - In the event of a printing error, press the dial and navigate to **Stop Print** and wait for the printer to stop moving, then navigate to Prepare:​Move Axis:Move Z:10 mm and turn the dial to move the extruder above the print bed.
   - After the print finishes, **wait for the bed to cool before removing it.**   - After the print finishes, **wait for the bed to cool before removing it.**
tools/3d_printing/creality_cr-10_s4.txt ยท Last modified: 2019/01/13 21:17 by username