Hacksburg Wiki

The wiki for Blacksburg's Workshop

User Tools

Site Tools


new_3d_printer

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
new_3d_printer [2017/05/23 16:00]
andrew
new_3d_printer [2017/05/23 16:00] (current)
andrew
Line 18: Line 18:
 **Cons:** **Cons:**
   * Expensive   * Expensive
-  * Bed-leveling solution not the best; may need tweaking (see [[http://​community.reprapwilson3d.com/​t/​simple-tweak-improves-accuracy-of-z-probe-switch-video/​897|here]] +  * Bed-leveling solution not the best; may need tweaking (see [[http://​community.reprapwilson3d.com/​t/​simple-tweak-improves-accuracy-of-z-probe-switch-video/​897|here]]) 
-  * Looks like higher-temp materials (PETG, Nylon) out of reach without hot end swap (see  [[http://​community.reprapwilson3d.com/​t/​e3d-v6-extruder-upgrade/​964|here]]+  * Looks like higher-temp materials (PETG, Nylon) out of reach without hot end swap (see  [[http://​community.reprapwilson3d.com/​t/​e3d-v6-extruder-upgrade/​964|here]])
   * May be possible to expand the build area, but a cursory check of the forums hasn't revealed anyone'​s experience with this; could be uncharted waters   * May be possible to expand the build area, but a cursory check of the forums hasn't revealed anyone'​s experience with this; could be uncharted waters
   * Still uses 8-bit Arduino knockoff on the main board; this isn't much of a downside, though, as many 3D printers will have this issue   * Still uses 8-bit Arduino knockoff on the main board; this isn't much of a downside, though, as many 3D printers will have this issue
new_3d_printer.txt · Last modified: 2017/05/23 16:00 by andrew